Related Manuals for RadioLink R8FG V2.1
Summary of Contents for RadioLink R8FG V2.1
- Page 1 R8FG V2.1 (FHSS) INSTRUCTION MANUAL Two-way Transmission PWM&SBUS Signal Supported 8-channel Receiver with Integrated Gyro...
- Page 2 If any problems found during the operation process, either way listed below can be used as online tech support. 1. Send mails to after_service@radiolink.com.cn and we will answer your question at the earliest. 2. Send private message to us on our Facebook page or leave comments on our YouTube page 3.
-
Page 3: Table Of Contents
RadioLink Electronic Ltd www.radiolink.com Contents 1. R8FG Introduction ........................... 3 2. Receiver Protocol Selection ........................3 3. Servo Speed Setting ..........................4 4. Binding ..............................4 5. Telemetry ..............................5 5.1 Telemetry of Signal and RSSI ......................6 5.2 Telemetry of model battery and receiver voltage ................6 6. -
Page 4: R8Fg Introduction
RadioLink Electronic Ltd www.radiolink.com 1. R8FG Introduction RadioLink R8FG 2.4G 8-channel receiver, splash-proof, with integrated gyro for professional car drifting and high voltage servo supported R8FG receiver is compatible with RadioLink RC8X/RC6GS V3/RC4GS V3/RC6GS V2/RC4GS V2/RC6GS (3-position switch version)/RC4GS (version with P.D AFTER 180101) /T8FB(BT) /T8S(BT)/T8FB(OTG)/T8S(OTG) transmitters. -
Page 5: Servo Speed Setting
(2) Receiver: If you are using a digital servo, you need to choose a servo speed of 4ms or 3ms. Please confirm whether the receiver you are using supports digital servo. Currently, R8FG V2.1 and R8FG with a factory date of 2023/4/26 and later support digital servo. Previous versions of R8FG, such as R8FG V1.0, does not support digital servos. -
Page 6: Telemetry
RadioLink Electronic Ltd www.radiolink.com Note: 1. When the transmitter and receiver are powered on, if binding is not successful or the signal is lost, the LED of R8FG will keep flashing to notify. 2. The close distance between the transmitter and receiver may cause a signal block, which leads to unsuccessful binding or signal loss. -
Page 7: Telemetry Of Signal And Rssi
60 centimeters, it is normal that RSSI value is within the range of 0 to -30dBm. The closer the value is to 0, the stronger the signal is. The range of RSSI value of RadioLink transmitters is from 0 to -99dBm. -
Page 8: Subsidiary Id
RadioLink Electronic Ltd www.radiolink.com Model battery voltage return can be easily achieved by connecting the male end of the battery wire to ESC while the female end to the battery and the wire with a JST head connects Telemetry (+-) port of R8FG/R7FG/R8F as below pic shown. -
Page 9: Working Modes
RadioLink Electronic Ltd www.radiolink.com car to run to the bucket of the truck, and then switch the receiver ID on the truck to drag the car back to the destination. Subsidiary ID mode setting steps: 1. Tap the button at the right of the "Subsidiary ID mode" to change it from "OFF" to "ON". Set the ID number according to your cars or boats and then finish the bind and parameters set for each receiver. -
Page 10: Working Mode Setting
RadioLink Electronic Ltd www.radiolink.com 7.1 Working mode setting Turn on/off the gyro: Short press the binding button 3 times within 2 seconds to switch the gyro on and off, and the color of the LED indicator will switch accordingly Gyro phase switch: Short press the binding button twice within 2 seconds to switch the gyro phase. -
Page 11: Gyro Sensitivity Adjustment
3ms, 4ms, 14ms can be selected (If you want to select 3ms or 4ms digital Response Latency servo speed, make sure it is R8FG V2.1, or R8FG receiver with a factory date of 2023/4/26 and later ) RC8X/RC6GS V3/RC4GS V3/RC6GS V2/RC4GS V2/RC6GS (3-position Compatible switch version)/RC4GS (version with P.D AFTER 180101) -
Page 12: Note Of Antenna Installation
8. Special vibration-proof material for R/C like foam or rubber cloth is used to pack to protect receiver. Keeping the receiver in a well sealed plastic bag can avoid humidity and dust, which would possibly make the receiver out of control. Thank you again for choosing RadioLink product.