RadioLink R6FG Manual

Fhss

Download this manual

Radiolink Electronic Limited

www.radiolink.com

R6FG

(FHSS)

Radiolink R6FG, 2.4GHz 6 channels receiver, gyro integrated and HV servo supported.

Compatible with Radiolink 6 channels pistol grip radio RC6GS, 4 channels pistol grip radio RC4GS,

RC4G, RC3S and 8 channels transmitter T8FB.

How to Match Code with Transmitter:

1. Put the transmitter and the receiver close to each other within 50 centimeters.

2. Turn on the transmitter, then power on the R6FG.

3. There is a black button on the R6FG, press the binding button twice in two seconds and release,

receiver light starts blinking, after about blinking 8 times, match code success then receiver signal

LED always on!

Page 1 2. Turn on the transmitter, then power on the R6FG. 3. There is a black button on the R6FG, press the binding button twice in two seconds and release, receiver light starts blinking, after about blinking 8 times, match code success then receiver signal...
Page 2 Radiolink Electronic Limited www.radiolink.com Attention: R6FG default have not turn on the gyro function. Make sure the R6FG keep motionless when power on it, because the R6FG will do the self-test. R6FG with two indicate LED, green LED on indicate normal working mode while both green and red LED on indicate gyro function working mode.
Page 3 Radiolink Electronic Limited www.radiolink.com Setup 1. Enable gyro Press binding key three time (interval less than 1 second), the red LED will flash three time, indicating whether gyro is enabled. 2. Gyro sensitivity Gyro sensitivity is predefined to adjust by channel three (factory set VR function), turning the VR switch clockwise to raise sensitivity and anti-clockwise to decrease.
Page 4 Radiolink Electronic Limited www.radiolink.com 7) Antenna length: 200mm 8) Control distance: more than 400 meters 9) Power supply: 4.8~10.0V DC 10) Channel resolution: 4096 11) Work current: 30mA 12) Compatible with transmitters: RC6GS, RC4GS, RC4G, RC3S, T8FB...