Related Manuals for RadioLink R8F
Summary of Contents for RadioLink R8F
- Page 1 RadioLink Electronic Ltd www.radiolink.com (FHSS) INSTRUCTION MANUAL 8-channel receiver Two-way Transmission Telemetry PWM&PPM&SBUS Signal Supported RadioLink Electronic Ltd www.radiolink.com.cn...
- Page 2 RadioLink Electronic Ltd www.radiolink.com Thanks for purchasing RadioLink 8-channel dual antenna receiver R8F. To fully enjoy the benefits of this product and ensure safety, please read the introduction carefully and set up the device as instructed steps. If any problems found during the operation process, please kindly refer to the manual first. Then you could contact our distributors to find solution or follow our Facebook homepage https://www.facebook.com/RadioLink-1455452961436694/...
-
Page 3: Table Of Contents
RadioLink Electronic Ltd www.radiolink.com Content 1. R8F Introduction..........................1 1.1 Compatible transmitters......................1 1.2 Binding............................1 2. Telemetry..............................2 2.1 Telemetry of Signal and RSSI....................2 2.2 Telemetry of Model Battery and Receiver Voltage..............2 3. Working Modes........................... 3 3.1 Standard working Mode......................3 3.2 PWM+SBUS/PPM Signal output working mode..............4 4. -
Page 4: R8F Introduction
Each receiver has an individual ID code and must bind with transmitter before using. When the binding is done, the ID code will be stored in the transmitter and there’s no need to rebind. Therefore, when a new R8F is purchased, binding needs to be done in order to work with transmitter. -
Page 5: Telemetry
RadioLink Electronic Ltd www.radiolink.com 2. Telemetry R8F can return the real-time information such as RSSI, receiver voltage and model battery voltage. In order to enjoy this function, please upgrade RC6GS(3-position switch version) with the firmware RC6GS_RadioLink_bin_1d15_V_6_0_0 downloaded via http://radiolink.com.cn/doce/Firmwares/RC6GS&R7FG.rar Or upgrade RC4GS(produced after 2018-01-01) with the firmware RC4GS_RX_RadioLink_bin_2f50_V_6_0_1 downloaded via http://radiolink.com.cn/doce/Firmwares/RC4GS&R7FG.rar... -
Page 6: Working Modes
Model battery voltage return can be easily achieved by connecting the male end of the battery wire to ESC while the female end to the battery and the wire with a JST head connects BAT (+-) of R7FG/R8F as below pic shown. No extra module is needed. 3. Working Modes R8F has two working modes：Standard working mode and S.BUS/PPWM signal output... -
Page 7: Pwm+Sbus/Ppm Signal Output Working Mode
Short press ID SET two times with interval less than 1s, the indicator from BLUE to RED ,meaning the working mode from SBUS/PPM signal output working mode to PWM working mode . 4. R8F Specifications 1) Frequency：2.4GHz ISM band(2400MHz~2483.5MHz) 2) Dimension: 34*21*11.5mm 3) Weight: 6.5g... - Page 8 RadioLink Electronic Ltd www.radiolink.com...