Subscribe to Our Youtube Channel
Related Manuals for RadioLink R8XM
Summary of Contents for RadioLink R8XM
- Page 1 RadioLink Electronic Ltd www.radiolink.com R8XM (FHSS) INSTRUCTION MANUAL Compatible Transmitters: T8FB(BT)/T8S(BT)/T8FB(OTG)/T8S(OTG)/RC6GS V3/RC6GS V2/RC6GS/RC4GS V3/RC4GS V2/RC4GS (must work with flight controller)
- Page 2 RadioLink Electronic Ltd www.radiolink.com Thanks for purchasing RadioLink 8-channel receiver R8XM. To fully enjoy the benefits of this product and ensure safety, please read the introduction carefully and set up the device as instructed steps. If any problems found during the operation process, please kindly refer to the manual first. Then you could contact our distributors to find solution or follow our Facebook homepage https://www.facebook.com/radiolinkofficial...
- Page 3 RadioLink Electronic Ltd www.radiolink.com Contents R8XM Introduction ........................ 3 Binding ..........................3 Working Modes ........................4 Note of Antenna Installation ....................4 Real-time Built-In Telemetry ....................4 Telemetry of RSSI and Receiver Voltage ............... 4 Telemetry of Model Voltage .................... 4 RSSI and Low Voltage Alarm Setting ................5 RSSI and Low Voltage Alarm Beeps ................
- Page 4 ID code will be stored in the transmitter and there’s no need to rebind. Therefore, when a new R8XM is purchased, binding needs to be done in order to work with transmitter. (Note: R8XM is not compatible with T8FB produced before December 2016) Binding steps Place the transmitter and R8XM receiver more than 50 cm apart.
- Page 5 Telemetry of RSSI and Receiver Voltage RSSI and receiver voltage will be displayed after the successful binding between the transmitter and the receiver. Telemetry of Model Voltage Connect the balance head of the battery to the telemetry port of R8XM, the model voltage will be...
- Page 6 RadioLink Electronic Ltd www.radiolink.com displayed. There is no need for an external power battery voltage telemetry module, and R8XM supports up to 6S (25.2V) battery voltage telemetry. Telemetry cable for 2S battery is standard packed by default. If you connect other batteries such as 3S，4S，5S, 6S battery, please change the telemetry cable by yourself.
- Page 7 Transmission: Telemetry of signal, RSSI, receiver voltage, model voltage ((The telemetry distance is the same as the control distance) Model Voltage Telemetry: 2S-6S LiPo battery (7.4V-25.2V) Compatible Transmitter: T8FB(BT)/T8S(BT)/T8FB(OTG)/T8S(OTG)/RC6GS V3/RC6GS V2/RC6GS/RC4GS V3/RC4GS V2/RC4GS (must work with flight controller) Thank you again for choosing RadioLink product.
Need help?
Do you have a question about the R8XM and is the answer not in the manual?
Questions and answers