Kingsman marquis SOLARA ZCV3622NE2 Installation Instructions Manual page 41

⚠ Caution
: The gas supply shall be shut off prior to disconnecting the electrical power, before proceeding
IMPORTANT: Always check for gas leaks with a soap and water solution. DO NOT USE OPEN FLAME FOR LEAK TESTING.
⚠
WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the
manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction.
If the information in these instructions is not followed exactly, a fire, explosion or production of carbon
monoxide may result causing property damage, personal injury or loss of life. The qualified service
agency is responsible for the proper installation of this kit. The installation is not proper and complete
until the operation of the converted appliance is checked as specified in the manufacturer's instructions
supplied with the kit.
ZCV3622 Burner System Removal
1. Remove Grate Bar
assembly or optional
Rock Platform by
removing the two
mounting screws, one
from each side.
2. Remove Log Support
Plates right and left of
burner, log support
plates are loose and
not fastened in place.
3. Loosen screws from
burner retainer tabs
and slide burner to the
left to remove from
orifice.
4. Remove main orifice
using a 1/2" wrench
and replace with new
conversion orifice.
5. Install new pilot orifice and Hi/Low valve regulator by following instructions supplied with conversion kit.
6. Adjust the primary air to the correct setting as specified in the manual or label plate. To adjust air setting, Loosen screw on the side
of air mixing tube and rotate to the correct opening using a drill bit or tape measure. Tighten screw.
7. After converting parts to the new type of gas, reverse all steps to reassemble burner system.
Conversion Kit Instructions – PART A
with the conversion.
Burner
Retainer
Plumbing
Access
Grate
Assembly
Burner
Retainer
41