Table of Contents
Advertisement
Inno Pocket Scan
Operating Modes: The Inno Pocket Scan can operate in three different modes. In each mode you
can run the fixture as a stand alone fixture or in a primary/secondary configuration. This next section
will detail the differences in the operating modes.
•
Sound Active mode - The fixture will react to sound, chasing through the built-in programs.
•
Show mode - The fixture will run one of 12 shows.
•
DMX control mode - This function will allow you to control each individual fixtures traits with a
standard DMX-512 controller.
Universal DMX Control: This function allows you to use a universal DMX-512 controller to control
the chases and patterns, dimmer and strobe. A DMX controller allows you to create unique pro-
grams tailored to your individual needs.
The Inno Pocket Scan has 6 DMX Channels. See the DMX Traits and Values section of this
•
manual for a detailed description of the DMX values and traits.
To control your fixture in DMX mode, follow the set-up procedures shown in the Set Up section
•
of this manual, as well as the set-up specifications that are included with your DMX controller.
•
Use your DMX controller's faders to control the various DMX fixture traits.
Follow the instructions in the System Menu section of this manual to set the DMX address.
•
•
For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
•
For help operating in DMX mode consult the manual included with your DMX controller.
Sound Active Mode: This mode allows either a single unit or several units linked together to run to
the beat of the music.
1. Press the MENU button until "SOUN" is displayed, and press ENTER. Press the UP or DOWN
buttons so that "ON" is displayed and press ENTER.
2. To adjust the sound sensitivity level, press the MENU button until "SENS" is displayed, and press
ENTER. Use the UP or DOWN buttons to adjust the sensitivity level. "0" is the least sensitive, and
"100" is the most sensitive. Press ENTER to set your level.
Show Mode: This mode allows either a single unit or several units linked together to run one of 12
pre-programmed, selectable shows. Show mode can run with or without sound active mode.
1. Press the MENU button until "SHND" is displayed, and press ENTER.
2. Press the UP or DOWN buttons until you find your desired show, press ENTER, then press and
hold the MENU button for at least 3 seconds to activate. After you have set your desired show, it
can be changed at any time using the UP or DOWN buttons.
ADJ Products, LLC - www.adj.com - Inno Pocket Scan User Manual Page 13
Operation
Advertisement
Table of Contents
