System Menu - ADJ INNO POCKET SCAN User Manual

Inno Pocket Scan
ADDR - DMX Address Setting.
1. Press the MENU button until "ADDR" is displayed, and press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER when you have found your desired DMX address, then press
and hold the MENU button for at least 3 seconds to set your desired DMX address.
3. Connect your DMX Controller.
SCND - This will let you set unit as a secondary in a primary/secondary configuration.
1. Press the MENU button until "SCND" is displayed, press ENTER. Either "PRI", "SEC1", or
"SEC2" will be displayed.
2. Press the UP or DOWN buttons until your desired setting is displayed, and press ENTER to con-
fim.
NOTE: Selecting "SEC2" on a fixture will cause that fixture to move in contrast to the primary fixture.
SHND: SH 0 - SH12 - Show modes 0-12 (Factory programs). Show mode can run with or with-
out sound active mode active.
1. Press the MENU button until "SHND" is displayed, and press ENTER.
2. "Sh X" will now be displayed, "X" representing a number between 0-12. Programs 1-12 are fac-
tory programs, while "Sh 0" is random mode. Press the UP or DOWN buttons to find your desired
show.
3. When you have found your desired show press ENTER, then press and hold the MENU button
for at least 3 seconds to activate. After you have set your desired show, it can be changed at any
time using the UP or DOWN buttons.
SOUN - Sound Active mode.
1. Press the MENU button until "SOUN" is displayed, and press ENTER.
2. The display will show either "ON" or "OFF". Press the UP or DOWN buttons to select "ON" to
activate sound active mode, or "OFF" to deactivate sound active mode.
3. Press ENTER, then press and hold the MENU button for at least 3 seconds to activate.
SENS - In this mode you can adjust the sound sensitivity.
1. Press the MENU button until "SENS" is displayed, and press ENTER.
2. A number between 0-100 will be displayed. Press the UP or DOWN buttons to adjust the sound
sensitivity. 0 is the least sensitive, and 100 is the most sensitive.
3. When you have found your desired setting press ENTER to confirm.
DIND - In this mode you can select the dimmer curve.
1. Press the MENU button until "DIND" is displayed, and press ENTER.
2. The current dimmer curve setting will be displayed.
3. Press the UP or DOWN buttons to find your desired dimmer curve and press ENTER to confirm.
See the Dimmer Curve Chart section of this manual for more information.
ADJ Products, LLC - www.adj.com - Inno Pocket Scan User Manual Page 9

System Menu