Perkins 1300 EDi Series Workshop Manual page 78

5
Crankshaft pulley / damper assembly
To remove
Special requirements
Special tools
Description
Crankshaft pulley puller
Note: Before removing the pulley / damper assembly check for alignment, see Operation 5-2.
1 Drain the lubricating system.
2 Remove the fan drive belt, see Operation 12-7.
3 Release and remove the three setscrews (A) that hold the retainer plate of the pulley / damper assembly.
4 Remove the retainer plate (A).
5 Use the puller 21825965 to remove the pulley / damper assembly (B).
Note: It is recommended that whenever the pulley / damper assembly is removed, the wear sleeve and seals
should be renewed.
A
66
This document has been printed from SPI². Not for Resale
Part number
21825965
B
W089
Peregrine EDi and 1300 Series EDi
Operation 5-1
Workshop Manual, TPD 1353E, Issue 3
W126