Perkins 1300 EDi Series Workshop Manual page 41

3
Peregrine EDi and 1300 Series EDi
Cylinder head assembly
To remove Operation 3-8
Warning! The cylinder head weighs 77 kg (170 lbs). Use lift equipment or obtain assistance to lift the cylinder
head.
1 Drain the cooling system.
2 Disconnect the high-pressure oil pipe (A1) at the supply manifold (A3).
3 Disconnect the fuel pipe (A2) at the supply manifold (A3).
4 Remove the rocker cover, see Operation 3-1.
5 Remove the rocker shaft assembly, see Operation 3-4.
6 Remove all the push rods and record their relative positions.
7 Remove all the pipes and hoses from the turbocharger.
8 Remove the exhaust manifold setscrews and remove the exhaust manifold and turbocharger as an
assembly. Remove the gasket for the exhaust manifold.
9 Release evenly and gradually then remove the cylinder head setscrews together with their washers.
10 Carefully separate the cylinder head from the cylinder block with a suitable lever (B).
11 Remove the cylinder head.
Caution: Put the cylinder head on blocks of wood to protect the tips of the fuel injector units.
2
1
3
A B
W207
W211/1
Workshop Manual, TPD 1353E, Issue 3 29
This document has been printed from SPI². Not for Resale