Advertisement
Installation Guide
Power Monitoring
E30E Series
Gateway
Configuration (cont.)
Z206792-0B
Page 15 of 24
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Shop for Power Metering products online at:
2. Set the IP address for use on the BACnet/IP network:
a. From the navigation tree (left column) on the GUI, click on Setup and then Network Settings to enter the Edit IP Address
Settings menu.
b. Enter the desired IP address in the N1_IP_Address field (in the format xxx.xxx.xxx.xxx)
c. If necessary, change the Subnet Mask by entering the appropriate new value in the N1_Netmask field
d. If the E30E is connected to an ethernet gateway, enter its IP address in the Default Gateway field. This is especially critical if
the E30E will be used as a BACnet BBMD device.
e. Click the Update IP settings button. The E30E changes its settings and restarts. The GUI does not connect again until the E30E
is installed on the network that matches those settings and the new IP address is entered into a web browser on a PC properly
configured for that network.
©2014 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
PowerMeterStore
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
www.
04142
1.877.766.5412
.ca
TM
Advertisement
