Advertisement
Installation Guide
Power Monitoring
E30E Series
Gateway
Configuration (cont.)
Z206792-0B
Page 12 of 24
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Shop for Power Metering products online at:
2. Temporarily change the IP address of the PC to a static value on the same subnet as the E30E. For example: If the E30E is set to
its factory default IP address of 192.168.1.24, set the PC to an unused static IP address on the 192.168.1.xxx subnet (where xxx
is any value between 1 and 255, except 24). Set the subnet mask to 255.255.255.0 (the screen captures in this example were
taken using Windows 7; other operating systems will look different).
a. Open the Control Panel:
b. In the Control Panel, select Network and Sharing Center. In the Sharing Center, select Change Adapter Settings in the list at
the upper left corner.
c. Select the connection for the setwork that the E30E is included on.
When the Local Area Connection Status windo appears, click on Properties
©2014 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
PowerMeterStore
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
www.
04142
1.877.766.5412
.ca
TM
Advertisement
