Advertisement
Installation Guide
Power Monitoring
E30E Series
Gateway
Configuration
Z206792-0B
Page 11 of 24
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Aerospond, Veris, and the Veris 'V' logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
Shop for Power Metering products online at:
Accessing the Graphical User Interface (GUI)
If the E30E IP address parameters are already configured to work on the network and is being accessed from a PC on that same
network, open a web browser and enter the IP address of the E30E into the address/URL field on the browser. Press enter. The GUI
launches and appears, as shown, in the browser window.
If the E30E IP address parameters are not configured for the network, connect a PC directly and access the GUI from it as follows:
1. Connect a standard CAT5 ethernet cable between a PC and E30E. Secure a ferrite filter (included) around the ethernet cable
to ensure the device meets emission requirements. If the user followed the Installation procedure in this document, then this
cable is already in place.
©2014 Veris Industries USA 800.354.8556 or +1.503.598.4564 / support@veris.com
PowerMeterStore
Other companies' trademarks are hereby acknowledged to belong to their respective owners.
www.
04142
1.877.766.5412
.ca
TM
Advertisement
