Accessories; Prior To Assembly - Bosch Rexroth LFA DB Series Operating Instructions Manual

24/48 Assembly
Bosch Rexroth AG, LFA...DB(W).-7X/...E, RE 21055-B/02.20

7.5 Accessories

The following accessories are recommended. They are not included in the scope of
delivery and can be ordered separately from Bosch Rexroth:
Table 10: Available accessories
Valve mounting set
Size 32
Size 40, 50
Size 63
The contents of the valve mounting set in each case consist of:
- 3 hexagon socket head cap screws ISO 4762 (standard)
- 1 mod. hexagon socket head cap screw ISO 4762 (with cross bore)
- 1 capstan head screw M6
- 1 lead seal
- 1 sealing wire
The valve mounting set specified above serves the optional sealing of a valve
mounting screw. For handling and use of the valve mounting set, please refer to
chap. 7.7.3 "Additionally sealing the control cover with the optional mounting set
after the assembly".

7.6 Prior to assembly

Check the scope of delivery for completeness and transport damage.
f
Compare the material number and the designation (type code) with the details in
f
the order confirmation.
If the material number of the safety valve does not match the number in the order
confirmation, contact the Rexroth service for clarification; for the address,
see chapter 16.1 "List of addresses".
Check whether the max. admissible flow is suitable for your application and/or
f
compatible with the hydraulic system.
The safety valves may only be operated within certain limitations of use.
The maximum admissible flow in [l/min] is always the last but one figure of the
component marking attached to the safety valve.
Check whether the present version of the safety valve (for ordering code of the
f
"sealing type" see "Data sheet 21055) is suitable for operation with the specified
hydraulic fluid.
Material number
R901476528
R901362574
R901362575