2. Bidet Installation
Remove original toilet seat:
•
Loosen bolts with the spanner.
•
Remove the nut and gasket.
•
Remove the toilet seat.
Installing the seat bracket:
•
Before the installation, place the product on the toilet bowl to check for correct
fitment.
•
Embed and install the rubber sleeve, seat bracket and metal gaskets as shown
below.
•
Insert the mounting bolts and tighten it so that the seat bracket cannot move.
•
If the product does not match the toilet bowl ideally, loosen the mounting bolts,
remove the metal gaskets, readjust the position of the seat bracket, then replace
the metal gaskets and tighten the bolts.
Bolt
Gasket
Nuts
Screw
Mounting bolts
Metal gaskets
Seat bracket
Rubber sleeves
Toilet
seat