Kogan KAWNDBIDETB User Manual page 15

10. Child
11. Position
12. Super
13. Auto
14. Water Temp
15. ECO
16. Deodoriser
17. Power
Note:
Idle mode means rear wash, front wash, dryer, flush, etc. are not enabled. Child wash,
one solution, strong wash, lady care must be enabled in idle mode.
Indicators
Power
Seat Temperature
Water Temperature
Clean
Energy Saver
Warm water gentle cleaning, suitable for children. In Idle mode, press this
button to enter function. The nozzle extends out to work and nozzle position
will be at the front (5 level), mini water pressured level) and the water temp is
set to 36°C. Automatically ends after 30 seconds unless Stop is pressed.
During this mode, cleaning position/ water pressure /water temp are not
adjustable.
Select from 5 levels, adjust the cleaning position by pressing + or – buttons.
Note: Under oscillating cleaning, the nozzle position adjustment is unavailable
Strong wash mode. In Idle mode, press this button to enter a powerful washing
mode, nozzle extends out. Water pressure is set to the highest level.
Automatically ends after 2 minutes unless Stop is pressed.
"One solution", Press this button to start in Idle mode to begin an automatic
sequence performing Rear Wash (40 seconds), Oscillate Wash (20 seconds)
and Warm Air Dryer (2 minutes). Press Stop to end this sequence.
The water temperature can be adjusted in 4 levels:
Room temperature
(No light)
Press the water temp button to cycle through the settings.
Low power mode. Press this button, the corresponding indicator will blink on
the control panel. After leaving the seat for 1.5 minutes the bidet will enter
power saving mode. Under this mode, seat temp is kept at 25°C and the
settings before power saving are automatically restored during next use.
Press this button to start deodorising, indicator on the control panel turns on.
Press again to turn off.
Note: During drying, the deodorising function is temporarily stopped and it will
automatically start again after drying is completed. When a person leaves the
seat, the deodorising function will continue to work automatically for 90
seconds.
Press this button to enter standby mode. All lights will be off. When pressed
again, the device will power on and the Power indicator will turn on.
Active when the bidet is powered on.
Flashing during a malfunction.
Active when the seat is heating.
Flashing if the seat is over heated.
Active when the water is heating.
Flashing if the water is over heated.
Flashing when water level is low.
Active when a user is seated.
Active when the bidet enters energy saving mode.
33°C 36°C
(Blue) (Green)
39°C
(Red)