Carrier XCT 7 40VCC727FQEE Operation & Installation Manual page 34

3.6 Fault Device Configuration
Equipment fault monitoring is divided into two parts: real-time fault alarm and history alarm. Real-time
alarm is mainly used to check the current equipment fault, while fault history is used to check the faults that
have occurred in the equipment, so as to facilitate follow-up maintenance and troubleshooting.
3.6.1 Current Fault
①
① checking icon, click "Current fault/History Falut/Current Pre-Alarm/History Pre-Alarm" switch to enter the
alarm interface
② Checking the gateway alarm , you can select all gateways, when the choice of all gateways, display all
the current alarm, and you can also check the gateway address failure, its only displayed the failure
gateway which is convenient troubleshooting system fault.
②
⑤
33
③
④