Table of Contents
Advertisement
It is also possible to debug your project from within e² studio without using
J-Flash Lite software for programming.
In that case, you simply have to have Debug
(1)
selected in your project and
click on Build button (2), followed by Launch in 'Debug' mode button (3).
Figure 8: e
2
studio – Project window
2
3
1
RA 4 M 1 C L IC K ER
Q U I C K S T A R T G U I D E
Advertisement
Table of Contents
Need help?
Do you have a question about the RA4M1 CLICKER and is the answer not in the manual?