Advertisement
Step 6
B19
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com-
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re-
quires a washer.
1
Position the rear corner panels at
the rear corners, as shown. The wid-
est part of each rear corner panel
must be placed along the rear of the
building. Attach the corner panels to
the floor frame with four screws.
2
Position a front corner panel at
the corner of the floor frame as shown.
The widest part of each front corner
panel must be placed along the front
of the building. A small gap will exist
between front corner panel and ramp.
Fasten the corner panel to the floor
frame with three screws.
NOTE
Be careful to install the correct
panel in each position as shown
3
Double-check the part numbers of
the wall panels, before proceeding.
The floor frame must be square
and level or holes will not align.
● Parts Needed For ●
Corners
9384
Narrow Side
STEP
1
SIDE
STEP
2
9380
STEP
9384
3
9380
Panels rest on
frame as shown
● ● ● ● ● 9380 Front Corner Panel (2)
● ● ● ● ● 9384 Rear Corner Panel (2)
Wide
Side
REAR
TOP VIEW
FRONT
9384
SIDE
9380
9384
9380
Washer
19
Advertisement
