Cleaning, Maintenance And Repair; Storage And Transportation; Disposal - Tarrington House QA18-0000001813 Assembly Instructions Manual

CLEANING, MAINTENANCE AND REPAIR

WARNING!
Always switch the appliance off and let it cool down before performing inspection, maintenance and cleaning work!
Cleaning
1. Clean the appliance after each use with a slightly damp cloth and a little soap. Use a brush for hard to reach places.
2. Remove stubborn dirt with high pressure air (max. 3 bar).
NOTE: Do not use chemical, alkaline, abrasive or other aggressive detergents or disinfectants to clean this appliance as they might be harmful to
its surfaces.
Stainless steel surfaces
1. Wipe all stainless steel surfaces with a wet soft cloth. Use a mild detergent to remove grease.
2. Remove grease and food remains from the fire box with a plastic or wooden spatula.
3. Remove the burner(s), before cleaning the fire box.
MAINTENANCE
Before and after each use, check the appliance or accessories or attachments for wear and damage. If required, exchange them for new ones as described in
this instruction manual. Observe the technical requirements (→ TECHNICAL DATA).
Burner
1. A conversion to a different gas type must be done by qualified personnel or your retailer only.
2. Clean the burner(s) at least once per year or whenever they get dusty.
3. Make sure that no dust or insects get inside the burner(s) openings or the air intake.
4. Clean the burner(s) with a pipe cleaner. Use a wire brush to clean any rust from the surface of the burner(s).
5. Make sure that the valve outlets of the valve unit are placed exactly in the air funnels of the / each burner, when assembling
the appliance.
6. Perform a visual check of the burner(s) flames regularly, do as follows:
a. Remove cooking grids and flame tamers.
b. Light the burner(s).
c. Turn control knob(s) from HI to LO. Check the flame status, the flame in LO position should be smaller than in HI
position (Fig. 1).
Always check flame before each use, if anything seems out of the ordinary (→ TROUBLESHOOTING).
REPAIR
This appliance does not contain any parts that can be repaired by the consumer. Contact a qualified specialist to have it checked and repaired.
WARNING!
Always make sure all safeguards, if available, have been reinstalled safely and correctly after each cleaning or maintenance! Never use the
appliance without its safeguards!

STORAGE AND TRANSPORTATION

STORAGE
1. Switch the appliance off.
2. Clean the appliance as described above.
3. Cover the burner(s) with aluminium foil so that no dust or insects collect inside.
4. Disconnect the gas cylinder(s) and store it / them in an outdoor location. Make sure that the gas cylinder(s) is / are not stored near heat sources or in direct
sunlight.
5. Do not store a spare gas cylinder under or near this appliance.
6. Store the appliance and its accessories in a dry, frost-free place. The ideal storage temperature is between 10 °C and 30 °C.
7. Always store the appliance in a place that is inaccessible to children.
8. We recommend using the original package for storage where possible or covering the appliance with a suitable cloth to protect it against dust.
9. Clean the appliance itself and the burner(s) thoroughly before use, if the appliance has been stored for a long period of time.
TRANSPORTATION
1. Switch the appliance off.
2. Attach transportation guards, if applicable.
3. Protect the appliance from any heavy impact or strong vibrations which may occur during transportation in vehicles.
4. Secure the appliance to prevent it from slipping or falling over.

DISPOSAL

Environmental Protection
Discarded electric appliances are recyclable and should not be discarded in the domestic waste! Please actively support us in conserving resources
and protecting the environment by returning this appliance to the collection centres.
Do not put your used batteries, nickel cadmium, rechargeable, round cell or starter batteries in with your household rubbish. Take them to an
appropriate disposal/collection site.
11
GB
1
MAX MIN