Tarrington House QA18-0000001813 Assembly Instructions Manual page 9

2 burner table top gas bbq

Table of Contents

Available languages

WARNING! Risk of explosion!

Always ignite the burner(s) within 5 seconds after turning the control knob to a position in between LO and HI. Gas can collect inside the

appliance causing an explosion on ignition.

WARNING!

Turn all the control knobs to the off positions OFF, if any burner does not ignite within 5 seconds. Wait for 5 minutes to let the gas dissipate and try

again.

WARNING!

If any burner still does not ignite after a few tries, it could indicate a problem with the gas supply. Turn the gas supply off on the appliance as

well as on the gas cylinder(s) and / or the pressure regulator(s). Do not use the appliance until the cause of the problem has been found (→

TROUBLESHOOTING).

Igniting the burner(s) with the electronic ignitor(s)

1. Push and turn the control knob of the selected burner to the HI position (Fig. 1). The electrode will spark to light the burner. The electronic ignitor sparks all

electrodes at once.

2. Set the control knob between HI and LO position (Fig. 2), to adjust the heat.

3. Ignite the other burner(s) using their respective control knob(s), after the first burner has fired up.

Igniting the burner(s) with a match

1. Light the match and insert it through the grill grates close to the burner you want to ignite (Fig. 1). Push and turn the control knob of the selected burner to

the HI position (Fig. 2).

2. Set the control knob between HI and LO position (Fig. 3), to adjust the heat.

3. Ignite the other main burner(s) using their respective control knob(s), after the first main burner has fired up. Push and turn the control knob(s) and set it to

the HI position to ignite it. The first main burner will ignite the nearby main burner through cross-lighting.