Table of Contents
Advertisement
Bevel Sanding
The work table on Model T27417 tilts from 0°–45°
for sanding bevels on your workpiece. The table
tilt stop bracket (see Figure 25) has detents for
quickly setting the most common angles: 0°, 15°,
22.5°, 30°, and 45°.
Note: You can bevel sand using either the spindle
sander or the edge-sanding attachment.
To bevel sand, set work table angle, use both
hands to maintain control of workpiece, and slow-
ly guide it against rotation of sanding surface until
desired results are achieved, then turn sander
OFF.
-22-
Setting Work Table Angle
1.
DISCONNECT MACHINE FROM POWER!
2.
Install spindle sander or edge-sanding
attachment.
3.
Loosen both table tilt lock knobs (see
Figure 25).
Work Table
Table Tilt
Stop Bracket
Figure 25. Location of table tilt components.
4.
Tilt table to desired angle.
Note: The table will automatically snap into
place at 0°, 15°, 22.5°, 30°, and 45°.
5.
Tighten both lock knobs to secure setting.
Model T27417 (Mfd. Since 09/15)
Table Tilt
Lock Knob
(1 of 2)
Advertisement
Table of Contents
