Grizzly T27417 Owner's Manual page 33

15. Install new ⁄ " drive belt (#89) onto lower pul-
1
4
ley assembly (#87).
16. Install ⁄ " drive belt (#89) onto drive pulley
1
4
(#61) with drive belt wrapped around proper
side of the tension roller assembly (#52), as
shown in Figure 41.
Drive
Pulley
Figure 41. ⁄ " drive belt installed onto drive
1
4
pulley and tension roller assembly.
17. Install spindle (#81) with upper pulley (#90)
and bearing sleeve.
18. Install Woodruff key (#83) into spindle (#81),
as shown in Figure 42.
Note: A piece of clear tape can be used
to ensure Woodruff key (#83) stays in
place during re-assembly.
Figure 42. Installing Woodruff key into spindle.
Model T27417 (Mfd. Since 09/15)
⁄ " Drive Belt
1
4
Tension
Roller
Assembly
Woodruff
Key
Spindle
19. Install new ⁄ " drive belt (#88) onto upper pul-
3
8
ley (#90).
20. Install upper pulley (#90) onto spindle (#81).
21. Slide
⁄ " drive belt (#88) onto drive pulley
3
8
(#61).
Note: Verify lower pulley (#87) and upper
pulley (#90) are properly mated together, and
that Woodruff key (#83) remains in place.
22. Install spindle washer (#81) and retaining ring
(#84), as shown in Figure 43.
Figure 43. Spindle washer and retaining ring
installed.
23. Install compression spring (#80), ensuring
hooked end is locked into upper pulley (#90)
shoulder, as shown in Figure 44.
Compression
Spring
Hooked End
Figure 44. Hooked end of compression spring
locked into upper pulley shoulder.
Spindle
Washer
Retaining
Ring
-31-