aventon LEVEL User Manual page 13

D. Use 4mm hex key to tighten front fork screws. (3pcs)
Step 7: Connect the display main line.
A. Remove rubber cover on display main line.
Note: When connecting the display line, align the arrows on the outer housing with each other to
ensure proper alignment.
Step 8: Use wrench to install the pedals. Locate the pedal with a smooth pedal axle exterior and an "R"
sticker label (1, below), which indicates it is the right pedal. The right pedal goes
on the crank on the right side of the bike (which has the drivetrain gears and is the same as a rider' s right
side when riding).
1. The right pedal (pedal with "R" sticker label) is threaded so that it is tightened by turning clockwise.
Apply grease to the thread and carefully thread the right pedal onto the crank on the right side of the bike
slowly and by hand. Do not cross thread or damage the threads.
2. The left pedal (pedal with "L" sticker label) is reverse-threaded and tightens counterclockwise.
indicating it is the left pedal. Apply grease and carefully thread the pedal onto the left crank by hand slowly.
Do not cross thread or damage the threads.
Torque each pedal to 35 Nm.
Identifying marks Right pedal tightens clockwise Left pedal tightens counterclockwise
Ensure the remaining pedal has notches on the exterior of the axle and an "L" sticker label (2, below).
B. Connect the display line by aligning the arrows on
the outer housing.
12