Before You Begin
Install and connect your HostRAID controller and internal disk drives (see
Create a bootable array (see
Create a driver disk (see next section).
Creating a Driver Disk
Before you install your driver, you will need to create a driver disk. You will need a floppy disk
to complete this task. To create a driver disk:
Set your system BIOS so that your computer boots from the CD drive. (For instructions,
1
refer to your computer's documentation.)
Click Create Driver Disk, from the Main Menu.
2
Select one of the operating systems from the list:
3
Windows
Linux
Netware
SCO OpenServer
Select the type of operating system you want to use.
4
Select the version of the operating system.
5
When prompted, insert a floppy disk, then click OK.
6
The system creates the driver disk.
Remove and label the driver disk.
7
Continue with the instructions for your operating system:
8
For Windows, see next section.
For Red Hat Linux, see
For SuSE Linux, see
For NetWare, see
For SCO OpenServe, see
Installing with Windows
You will need your Windows Installation CD to complete this task. To install the HostRAID
controller driver while installing Windows:
Insert your Windows CD, then restart the computer.
1
Follow the on-screen instructions to begin the Windows installation.
2
When prompted to install a third-party driver, press F6.
3
Note:
seconds. If you miss your chance to press F6, restart your computer.
Chapter 7: Installing the Driver and an Operating System
page
28).
page
34.
page
34.
page
35.
page
36.
When F6 is active, a prompt appears at the bottom of the screen for only 5
33
page
23).