Default Settings - Adaptec 3940-AUW Installation Manual

3

Default Settings

AHA-3940AU/AUW host adapters operate cor-
rectly with their factory default settings in most com-
puters with PCI slots. The following table lists the
settings and their default values. You can change
these settings with the SCSISelect utility. (See
Configuring the Host Adapter on page 8.)
SCSI Bus Interface Definitions
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Boot Device Settings
Boot Channel
Boot SCSI ID
Boot LUN Number 1
SCSI Device Configuration
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation 4
Send Start Unit Command 5
BIOS Multiple Lun Support 5
Include in BIOS Scan
Advanced Configuration Options
Plug and Play SCAM Support
Reset SCSI Bus at IC Initialization
Extended BIOS Translation for DOS Drives > 1 GByte 5
Host Adapter BIOS (Configuration Utility Reserves BIOS
Space)
Support Removable Disks under BIOS as Fixed Disks 5
Display <Ctrl-A> Message During BIOS Initialization 5
BIOS Support for Bootable CD-ROM 5
BIOS Support for Int 13h Extensions 5
1. Setting is valid only if Multiple LUN Support is enabled.
2. Default Setting for the AHA-3940AU is 10 MBytes/sec.
Default Setting for the AHA-3940AUW is 20 MBytes/sec.
3. Ultra speed for the AHA-3940AU is 20 MBytes/sec.
Ultra speed for the AHA-3940AUW is 40 MBytes/sec.
4. AHA-3940AUW only
5. Settings are only valid if channel BIOS is enabled.
AHA-3940AU/AUW Installation Guide
Part Number: 511418-00, Rev. A
Print Spec Number: 496346-00
Current Date: 3/12/97
Default Setting
7
Enabled
Automatic
Default Setting
A First
0
0
Default Setting
Yes (Enabled)
10 MBytes/sec 2 , 3
Yes (Enabled)
Yes (Enabled)
No (Disabled)
No (Disabled)
Yes (Enabled)
Default Setting
Disabled
Enabled
Enabled
Enabled
Boot Only
Enabled
Enabled
Enabled
3
ECN Date:3/10/97