Default Setting - Adaptec AHA-3940U Installation Manual

3

Default Setting

AHA-3940U/3940UW/3940UWD host adapters
operate correctly with their factory default settings
in most computers with PCI slots. The following
table lists the settings and their default values. You
can change these settings with the SCSISelect utility.
(See Configuring the Host Adapter on page 8.)
Global Settings for Host Adapter
Host Adapter SCSI ID
SCSI Parity Checking
Host Adapter SCSI Termination
Boot Device Settings
Boot Channel
Boot Target ID
Boot LUN Number 1
SCSI Device Settings
Initiate Sync Negotiation
Maximum Sync Transfer Rate
Enable Disconnection
Initiate Wide Negotiation 3
Send Start Unit SCSI Command 4
Advanced Host Adapter Settings
Plug and Play SCAM Support
Channel BIOS
Support Removable Disks under BIOS as Fixed Disks 4
Extended BIOS Translation for DOS Drives > 1 GByte 4
Display <Ctrl-A> Message During BIOS Initialization 4
Multiple LUN Support 4
BIOS Support for Bootable CD-ROM 4
BIOS Support for Int 13h Extensions 4
Support for UltraSCSI Speed 5
1 Setting is valid only if Multiple LUN Support is enabled.
2 10 MBytes/sec for AHA-3940U.
3 AHA-3940UW/3940UWD only.
4 Settings are only valid if channel BIOS is enabled.
5 If this setting is changed to Enabled, the Maximum Sync Transfer Rates are
20 MBytes/sec for the AHA-3940U and 40 MBytes/sec for the AHA-3940UW/
3940UWD.
3
AAAA A AAAA AAAA AAAA AAAA AAAA AAAA AAAA
A AAAA AAAA AAAA AAAA AAAA AAAA AAAA AAAA
A
AHA-3940U/3940UW/3940UWD Installation Guide
A
A
A
Part Number: 511040-00, Rev. B
A A
A
Print Spec Number: 494568-00
A
A
A
Current Date: 11/14/96
A A
AAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAA
Default Setting
7
Enabled
Automatic
Default Setting
A First
0
0
Default Setting
Yes (Enabled)
20 MBytes/sec 2
Yes (Enabled)
Yes (Enabled)
No (Disabled)
Default Setting
Disabled
Enabled
Boot Only
Enabled
Enabled
Disabled
Enabled
Enabled
Disabled
AAAA AAAA AAAA AAAA AAAA AAAA AAA
AAAA AAAA AAAA AAAA AAAA AAAA AAA A
A
A
A
A
A A
A
A
A
A
ECN Date:11/18/96
A A