Answer By Voice Command - Panasonic Link2Cell KX-TGD862 Operating Instructions Manual

Answer by Voice Command

Answer by voice command
This feature allows you to answer incoming
calls automatically with your voice. When your
voice is detected, answered calls will
automatically be directed to the speakerphone
mode. The default setting is "Off".
Important:
R Before using this feature, we recommend
that you test it and adjust the voice
command sensitivity as needed.
R For best performance, answer the call
within a range of 50 cm (20 inches) to 1 m
(40 inches).
R Once this feature is turned on, the Talking
Caller ID will be activated automatically. To
turn off the Talking Caller ID feature, see
page 44.
R Ambient noise (dog barking, TV sound,
etc.) may cause the unit to answer an
incoming call.
R When this feature is used, the unit
disconnects the call automatically after 3
minutes. You may hear a warning tone and
the unit may prompt you to press * to
continue talking 1 minute before
disconnecting.
R Even if you press any key operations during
a call, the call is continued.
Note:
R When a call is manually answered using a
unit, voice detection will end, and the
answer by voice command feature stops
operating.
R This feature is not available while baby
monitor is set to "On" (page 47).
R The configured settings are common for all
lines (landline and cellular lines).
Turning answer by voice command
on/off
1
Press and hold * for about 2 seconds.
2
MbN: Select the desired setting. a
MSAVEN
R If you selected "Off", go to step 4 to
exit.
For assistance, please visit http://shop.panasonic.com/support
28
TA Manual_TGD86x_0921.pdf 28
3
MYesN a The unit will announce the
voice command guidance.
R We recommend answering calls as
demonstrated.
R There must be a 1 second pause
between the two phrases.
4
To stop: Press MSTOPN.
To playback: Press MYESN.
To exit: Press MOFFN.
Note:
R When answer by voice command is set to
"On", only use "Tone 1" to "Tone 5" as
your ringer tone (page 42, 44). If
another ringer tone is selected, the unit will
automatically use the default ringer tones
(Landline: "Tone 1", CELL 1: "Tone 2",
CELL 2: "Tone 4").
Answer by voice command sensitivity
You can adjust the sensitivity of the answer by
voice command. Increase or decrease the
sensitivity to adjust the sound level needed to
trigger the answer by voice command feature.
1
MMENUN#107
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Answering calls
1
When the unit rings, speak clearly as
demonstrated by the voice guidance.
Refer to step 3, "Turning answer by voice
command on/off", page 28.
2
When you finish talking, press MOFFN.
2020/09/21 16:00:00