Panasonic Link2Cell KX-TGD862 Operating Instructions Manual page 60

Using Bluetooth® Devices
Pairing a Bluetooth headset to
the base unit
Important:
R Make sure that the Bluetooth headset is not
connected to any other Bluetooth device.
1
Bluetooth headset:
Set your headset to pairing mode.
R Refer to the headset's operating
instructions.
2
Handset:
MMENUN#621
3
If your headset PIN is "0000", go to
step 4.
If your headset PIN is not "0000",
press MCLEARN, then enter your
headset's PIN.
R Typically, default PIN is "0000". Refer
to the headset's operating instructions.
4
Press MOKN, then wait until a long beep
sounds.
5
MOFFN
R When the Bluetooth headset is ready
for use, the HEADSET indicator on the
base unit lights up.
Connecting/disconnecting a
Bluetooth headset
If you cannot connect the headset and base
unit using the headset, you can connect using
the handset.
To use your headset with another Bluetooth
device such as a cellular phone, you may
need to disconnect it from the base unit.
Important:
R Make sure that the headset is turned on.
1
To connect/disconnect:
MMENUN#622
R A long beep sounds.
2
MOFFN
Unpairing a Bluetooth headset
You can cancel a pairing of the headset that is
stored to the base unit.
1
MMENUN#612
For assistance, please visit http://shop.panasonic.com/support
60
TA Manual_TGD86x_0921.pdf 60
2
MbN: "Yes" a MSELECTN
R When the headset is unpaired, the
HEADSET indicator is turned off.
3
MOFFN
Operating a Bluetooth headset
using a landline
Important:
R Refer to your headset's operating
instructions for details.
R Some features described here may not be
available depending on Bluetooth headset.
Answering landline calls with your
headset
To answer a landline call, press your
headset's button.
When you finish talking, press your headset's
button.
Note:
R If you cannot hang up the call using your
headset, press M N (STOP) on the base
unit.
Call sharing between your headset
and the handset
Important:
R To activate this feature, you should set call
sharing mode to on beforehand (page 46).
n While the handset is on a landline call:
To join the conversation with your headset,
press your headset's button.
n While your headset is on a landline call:
To join the conversation with the handset,
press M N.
Switching between the base unit and
your headset
You can switch from the base unit to your
headset while listening to messages recorded
on the base unit answering system.
R You can only switch from the base unit to
your headset.
2020/09/21 16:00:01