Answer By Voice Command - Panasonic KX-TGF850 Operating Instructions Manual

Answer by voice command

This feature allows you to answer incoming calls
automatically with your voice. When your voice is
detected, answered calls will automatically be
directed to the speakerphone mode. The default
setting is "Off".
The answer by voice command feature functions
as follows:
n When the handset is on the base unit:
– Only the handset performs voice detection.
To avoid interfering with voice detection, the
base unit will not ring.
n When the handset is not on the base unit:
– All registered handsets and base unit perform
voice detection.
Important:
R Before using this feature, we recommend that
you test it and adjust the voice command
sensitivity as needed.
R For best performance, answer the call within a
range of 50 cm (20 inches) to 1 m (40 inches).
R Once this feature is turned on, the Talking
Caller ID will be activated automatically. To turn
off the Talking Caller ID feature, see page 38.
R Ambient noise (dog barking, TV sound, etc.)
may cause the unit to answer an incoming call.
R When this feature is used, the unit disconnects
the call automatically after 3 minutes. You may
hear a warning tone and the unit may prompt
you to press * to continue talking 1 minute
before disconnecting.
R Even if you press any key operations during a
call, the call is continued.
Note:
R When a call is manually answered using a unit,
voice detection will end, and the answer by
voice command feature stops operating.
R This feature is not available while baby monitor
is set to "On" (page 41).
Turning answer by voice command on/off
Handset / Base unit
1
Press and hold * for about 2 seconds.
2
MbN: Select the desired setting. a MSAVEN
R If you selected "Off", go to step 4 to exit.
For assistance, please visit http://shop.panasonic.com/support
Answer by Voice Command
3
MYESN a The unit will display and announce
the voice command guidance.
R We recommend answering calls as
demonstrated.
R There must be a 1 second pause between
the two phrases.
4
Proceed with the operation for your unit.
Handset:
– To stop, press MSTOPN.
– To playback, press MYESN.
– To exit, press MOFFN.
Base unit:
– To stop, press M N.
– To playback, press MYESN.
– To exit, press MEXITN.
Note for handset:
R When answer by voice command is set to "On",
only use "Tone 1" to "Tone 5" as your ringer
tone. If another ringer tone is selected, the unit
may prompt you to change the setting in step 2.
Otherwise, the unit will automatically use "Tone
1" as the default ringer tone. Change the ringer
tone as needed (page 38).
Answer by voice command sensitivity
You can adjust the sensitivity of the answer by
voice command. Increase or decrease the
sensitivity to adjust the sound level needed to
trigger the answer by voice command feature.
Handset / Base unit
1
MMENUN#107
2
MbN: Select the desired setting. a MSAVEN
3
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Answering calls
Handset / Base unit
1
When the unit rings, speak clearly as
demonstrated by the voice guidance. Refer to
step 3, "Turning answer by voice command on/
off", page 21.
2
When you finish talking, press MOFFN on the
handset or MZN on the base unit.
21