Panasonic Link2Cell KX-TGD862 Operating Instructions Manual page 50

Programming
3
MbN: Select the desired unit's number to
monitor with. a MSAVEN
R "Baby monitor" will be displayed.
R The registered unit's name/number is
displayed.
Note:
R When this feature is on, another handset or
the base unit can hear the monitored
handset by making an intercom call.
To monitor from outside
If you enable this feature, the unit will call a
pre-programmed phone number when the
handset detects sound. After you answer the
call, you can listen in on the room where the
handset is located.
This feature is only available for landline.
n From the phonebook:
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select "Outgoing call" to
monitor from outside. a MADDN
4
MbN: "Phonebook" a MSELECTN
5
MbN: Select the phonebook entry. a
MSAVEN
R "Baby monitor" will be displayed.
Note:
R If you edit a phonebook entry which is
assigned for monitoring, the edited entry
does not transfer to the monitor.
n By entering phone numbers:
1
MMENUN#268
2
MbN: "On" a MSELECTN
3
MbN: Select "Outgoing call" to
monitor from outside. a MADDN
4
MbN: "Manual" a MSELECTN
5
Enter the desired name. a MOKN
6
Enter the desired number. a MOKN
a MSELECTN
R "Baby monitor" will be displayed.
Note:
R The registered name/number is displayed.
For assistance, please visit http://shop.panasonic.com/support
50
TA Manual_TGD86x_0921.pdf 50
Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to "On".
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "Off" a MSELECTN a MOFFN
Editing an outside monitoring number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line. a MMENUN
5
MbN: "Edit" a MSELECTN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a
MOKN a MSELECTN
Erasing an outside monitoring
number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line. a MMENUN
5
MbN: "Erase" a MSELECTN
6
MbN: "Yes" a MSELECTN a MOFFN
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity level" a
MSELECTN
2020/09/21 16:00:01