Removing Hard Disk Drives - NEC N8100-1983F User Manual

Chapter 2 Preparations
6. Mount the HDD trays that come with the HDD
cage from both sides of the 3.5-inch hard disk
drive. Mount the tray marked "A" on the left side,
and the tray marked "B" on the right side. Mount
the hard disk drive so that the flat face of the
hard disk drive faces downward.
7. Insert the hard disk drive attached to the tray
into the slot of the HDD cage.
When it is pushed to the end, it locks with a
click.
8. Connect the signal cable and the power cable to the hard disk drive. Use the signal cable that come
with the HDD cage. Use the power cable connected to the motherboard in advance. For details about
cable connection, see Chapter 2 (1.15.1 Internal interface cables).
9. Attach the front bezel and the side cover you removed in step 2.

1.12.2 Removing hard disk drives

Remove the hard disk drives by using the following procedure.
1. See Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. To remove the side cover and the front bezel, see Chapter 2 (1.4 Removing the Side Cover and 1.5
Removing the Front Bezel).
3. Disconnect the power cable and signal cable from the hard disk drives.
4. Press the part shown in the figure to unlock the HDD tray, and then remove the hard disk drive out
from the HDD cage.
5. Assemble the server.
Important
When disposing of the hard disk drives, follow the instructions described in
Chapter 1 (1.2 Disposal of the Server and Consumables) in the Maintenance
Guide.
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
A
B
79