Table of Contents
Advertisement
Chapter 2 Preparations
Connecting to a RAID Controller
1.
Connect another connector of the flash backup unit control cable to the connector on the RAID
controller. Check the marker of the connector and connect the cable straight into the connector.
Be careful not to press it in at an angle when connecting.
Position of the connector
Connect the cable to the connector shown in the figure below.
2.
Install the RAID controller into the PCI slot #4 and fix it in place. Be careful not to disconnect the
cable.
3.
Connect the cables and components that you removed.
1.10.5 Removal
To remove the flash backup unit, reverse the installation procedure.
RAID Controller
RAIDController
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
Black Marker
67
Advertisement
Table of Contents
