Table of Contents
Advertisement
Chapter 2 Preparations
1.8.4
Removal
Remove a DIMM in the following procedure.
1.
See the steps 1 to 5 in Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2.
Open both levers of the target DIMM slot
outward.
The DIMM is unlocked
3.
Remove the DIMM by pulling it out from
the slot in a straight direction.
4.
Assemble the server.
5.
Turn on the server and confirm that no error messages are displayed on POST. If any error message
is displayed, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
6.
If you replaced a broken DIMM, choose Yes in Memory Configuration-Memory Retest of the
Advanced menu, and then choose Save Changes and Exit to restart.
7.
Set the paging file size to the recommended value (Total memory size x 1.5) or more.
When using a Windows OS, see Chapter 1 (6.1 Specifying Memory Dump Settings (Debug
Information)) in "Installation Guide (Windows)".
For other OS, see the manual provided with the operating system or contact your sales
representative.
54
• When removing a defective DIMM, check error messages displayed at POST or
Note
NEC ESMPRO and check the DIMM slot where the defective DIMM is installed.
• At least one DIMM needs to be installed for the server to operate.
Important Do not apply too much pressure when you pull a DIMM out from the
socket.
Express5800/T110f-S User's Guide
1. Installing Internal Optional Devices
Advertisement
Table of Contents
