Table of Contents
Advertisement
Do not put this device close to a place where a heat source exits or high
temperature occurs. Avoid placing the device in direct sunlight.
Do not put this device close to a place where it is high moisture or wet. Do
not spill any fluid on this device.
FCC Statement
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment. This device
complies with Class B Part 15 and Part 68 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause
undesired operation.
Note: this equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures: reorient or relocate the receiving antenna, increase the separation
between the equipment and receiver, connect the equipment into an outlet on a circuit
different from that to which the receiver is connected, and/or consult the dealer or an
experienced radio/TV technician for help.
FCC Radiation Exposure Statement: This equipment complies with radiation exposure
limits and should be installed and operated with minimum distance 20cm between the
radiator and your body. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
FCC - PART 68
This equipment complies with Part 68 of the FCC rules and the requirements adopted
by the ACTA. On the bottom case of this equipment is a label that contains, among
other information, a product identifier in the format US: MTLDL01AMD1600 and REN:
0.1A for this equipment.
This equipment uses the following USOC jacks: RJ-11/RJ45/USB/Power Jacks!
A plug and jack used to connect this equipment to the premises wiring and telephone
network must comply with the applicable FCC Part 68 rules and requirements
adopted by the ACTA. A compliant telephone cord and modular plug is provided with
this product. It is designed to be connected to a compatible modular jack that is also
compliant. See installation instructions for details.
User Manual
2
Advertisement
Table of Contents
