Table of Contents
Advertisement
Fault/malfunction
Pressure washers does not
work
Pressure too low, but steady
Leaks in the Pressure washer
Irregular operating pressure
The high-pressure washer
operates intermittently
Y 2200BL indd 22
cause
No electrical voltage at the
device
On/off switch set to "0"
Cross section of the extension
cord no large enough and/or the
extension cord is too long
Extension cord damaged
The protector on the PCB has
activated
The mains voltage is lower than
that specified
The pump is frozen
Wrong spray tips was selected
Hight-pressure hose are
damaged or leaks in the
connection
Leaks from the pump or internal
connections
Hose connections loose
Air intake in the water inlet
The water filter is clogged
Water supply hoses squeezed
Inadequate water supply
Power cord is damaged
Internal loose electrical
connection
On/Off switch defective
22
Remedy
Check the fuse, power cord,
power plug and power source
and have them replaced by
qualified personnel if necessary
On/off switch set to "I"
Use extension cord with lager
cross sections and/or use
shorter extension cords
try without extension cord
Switch off the Pressure washer
and pull the plug out from the
power source, then restart the
Pressure washer
Contact the power supply
company if necessary
Check and thaw if necessary
Change to right spray nozzles
Change the hight-pressure
hose or hand-tighten the screw
connection
Consult customer service
Hand-tighten the water intake
adapter and the high-pressure
hose screw connection
Check the supply hose and
hose connection and replace if
necessary
Clean the water filter
Straighten out kinked water
supply hoses
Check the water supply
Consult customer service
Consult customer service
Consult customer service
15-4-29
6 32
Advertisement
Table of Contents
