Yard force YF2200BL Operator's Manual page 18

Fig.19
CaUtiON!
for around 5 seconds.
To switch the pressure washer on, set the On/Off switch to ON.
1. Unlock the safety trigger lever on the spray gun, and press the trigger lever until
there is a steady stream of water.
CaUtiON!
which controlled by software. after switching on for 10 seconds, the motor will
reach to the rated operating speed.
to temporarily switch off
Release the trigger lever, at this point the equipment goes to standby. As soon as
you press the trigger lever again, the equipment restarts.
to completely switch off
as shown in Fig. 20
1. Release the trigger lever, and replace the safety lock.
2. To switch the pressure washer off, set the On/Off switch to OFF.
3. Close the water inlet valve.
CaUtiON ! After releasing the trigger for 10 seconds, the motor can be
completely stopped, due to this pressure washer is soft stop function which
controlled by software.
Y 2200BL indd 16
Before switching on, first purge pump by squeezing trigger handle
this pressure washer is equipped with sOFt start FUNCtiON,
Fig.20
16
15-4-29 6 32