Qos Shaper: Add/Edit - ZyXEL Communications SBG5500 Series User Manual

Figure 151 Configuration > Bandwidth Management > Shaper Setup
The following table describes the labels in this screen.
Table 93 Configuration > Bandwidth Management > Shaper Setup
LABEL
Add
Edit
Remove
Multiple Entries Turn On
Multiple Entries Turn Off
#
Status
Outgoing Interface
Rate Limit (kbps)

11.6.1 QoS Shaper: Add/Edit

Click Add in the Shaper Setup screen or select a shaper and click Edit to show the following screen.
Figure 152 Shaper Setup: Add/Edit
The following table describes the labels in this screen.
Table 94 Shaper Setup: Add/Edit
LABEL
Enable
Outgoing Interface
Rate Limit
Chapter 11 Bandwidth Management
DESCRIPTION
Click this to create a new shaper.
Double-click a shaper or select it and click Edit to open a screen where you can
modify the shaper's settings.
To remove an existing shaper, select it and click Remove. Note that subsequent rules
move up by one when you take this action.
Select one or more shapers and click this to enable them.
Select one or more shapers and click this to disable them.
This is the index number of the entry.
This field displays whether the shaper is active or not. A green ON button signifies that
this shaper is active. A gray OFF button signifies that this shaper is not active.
Click the slide button to turn on or turn off the shaper.
This shows the name of the SBG's interface through which traffic in this shaper
applies.
This shows the average rate limit of traffic bursts for this shaper.
DESCRIPTION
Select the check box to activate this shaper.
Select the SBG's interface through which traffic in this shaper applies.
Enter the average rate limit of traffic bursts for this shaper.
SBG5500/3310 Series User's Guide
207