ZyXEL Communications SBG5500 Series User Manual page 202

Table 90 Classification Setup: Add/Edit (continued)
LABEL DESCRIPTION
Class Name Enter a descriptive name for the classifier. You can use up to 31 alphanumeric characters, it
must begin with a letter. The valid characters are [0-9][a-z] [A-Z][_-].
Order Select an existing number for where you want to put this classifier to move the classifier to the
number you selected after clicking OK. Ordering your classifiers is important because the SBG
applies the classifiers in the order that you specify.
Basic Criteria Configuration
From Interface If you want to classify the traffic by an ingress interface, select an interface from the From
Interface drop-down list box.
Ether Type Select a predefined application to configure a class for the matched traffic.
If you select IP, you also need to configure source or destination MAC address, IP address,
DHCP options, DSCP value or the protocol type.
If you select 802.1Q, you can configure an 802.1p priority level.
Source Criteria Configuration
Address Select the check box and enter the source IP address in dotted decimal notation. A blank
source IP address means any source IP address.
Subnet Enter the source subnet mask.
Netmask
Starting Port Enter the starting port of the source.
Ending Port Enter the ending port of the source,
MAC Address Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet's MAC address
should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC address should
match. Enter "0" for the bit(s) of the matched traffic's MAC address, which can be of any
hexadecimal character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and
the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this
criteria.
Exclude Select this option to exclude the packets that match the specified criteria from this classifier.
Destination Criteria Configuration
Address Select the check box and enter the source IP address in dotted decimal notation. A blank
source IP address means any source IP address.
Subnet Enter the source subnet mask.
Netmask
Starting Port Enter the starting port of the source.
Ending Port Enter the ending port of the source,
MAC Address Select the check box and enter the source MAC address of the packet.
MAC Mask Type the mask for the specified MAC address to determine which bits a packet's MAC address
should match.
Enter "f" for each bit of the specified source MAC address that the traffic's MAC address should
match. Enter "0" for the bit(s) of the matched traffic's MAC address, which can be of any
hexadecimal character(s). For example, if you set the MAC address to 00:13:49:00:00:00 and
the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56 matches this
criteria.
Exclude Select this option to exclude the packets that match the specified criteria from this classifier.
Other Criteria Configuration
Chapter 11 Bandwidth Management
SBG5500/3310 Series User's Guide
202