Wet System - Husqvarna K770 SmartGuard Workshop Manual

3. Use a plastic hammer and push the axle down until
the spacer touches the inner stop in the bearing
housing.
4. Put the shaft bearing on the axle and put the axle in
the support for assembly.
5. Use the assembly support to make the bearing
housing level.
1453 - 001 - 02.04.2020
6. Put the axle with the blade shaft bearing in the
bearing housing with the spacer down.
7. Use a plastic hammer and push down the axle.

6.15 Wet system

6.15.1 Function
Each side of the blade guard has a spray nozzle. The
water hits a section of the cutting blade and the
centrifugal force moves it out to the edge. The spray
nozzles are available with many different hole diameters
Repair and servicing - 65