Wet System - Husqvarna K 760 Workshop Manual

16
51

WET SYSTEM

Wet system
Design
A spray nozzle is located on each side of the blade guard. The water strikes a
section of the cutting blade and the centrifugal force carries it out towards the
blade's diamond segment.
The spray nozzles are available with several different hole diameters depen-
ding on the type of machine and application. Find the right nozzle in the
spare parts list.
Replacing the spray
nozzles
Remove the screw.
Remove the spray nozzle.
Fit the right dimension
Check in the spares list that the
spray nozzle with the correct
dimension is fitted.
Light tightening
Tighten the spray nozzles with a
light force.
Filter replacement
Remove with a wood screw.
Fit on an even surface.
Hose clips
The hose clips can be reused.
Open the hose clip using a
screwdriver.
Close the hose clip using
pliers.
Replacing the spray nozzles
The intake is located with special screws
that direct the water to the spray nozzles
underneath.
Remove the screw.
Remove the spray nozzle.
Fit the right dimension
Check in the spares list that the spray
nozzle with the correct dimension is
fitted.
Light tightening
The spray nozzles have a thin material
between the outer and inner thread.
Tighten the spray nozzles with a light
force.
Filter replacement
A normal wood screw works excellently as
a removal tool for the filter. Screw the
screw into the filter and pull this out.
Fit the filter by pressing it in on a flat
surface.
Hose clips
The hose clips in the wet cutting system
are of the type that can be reused.
Open the hose clip by pushing up the
lock catch with a screwdriver.
Close the hose clip by pressing it to -
gether with some pliers.
115 32 40-26