Ignition System - Husqvarna K 960 Workshop Manual

6
1
3
1
14

IGNITION SYSTEM

2
4
2 3
502 51 34-02
Test the short-circuit cable and
stop switch
Test using a measurement instrument or
the following simple solution: Connect a
battery in series with a test lamp to the
short-circuit cable and engine body.
Watch the test lamp while testing the
function of the stop switch. The lamp
should not be lit when the stop switch is
in the operating mode.
If the lamp is lit – first check the
condition of the insulation on the short-
circuit cable and that it makes contact
with the engine body. Now check the
stop switch.
Dismantling the stop switch
1. Remove the screw.
2–4. Pry the switch to the left using a
large screwdriver and pull out the right-
hand side of the switch first.
Assembling the stop switch
1. Push the switch towards the snap-in
lock.
2. Push in the right hand side.
3. Push in the left-hand side to secure the
switch in the snap-in lock. Fit the screw.
Replacing the ignition module
The ignition module is secured by two
screws to the engine body.
When assembling the new module, the
flywheel with magnets is turned towards
the ignition module.
Place air gap gauge (.01 in./0.3 mm)
502 51 34-02 against the magnets and fit
the new module in position.
The screws should be tightened to a
torque of 6.6–8.1 lbf·ft/9–11 Nm.