Repair Instructions; To Clean And Examine The Product Parts; To Repair Damaged Threads; Wet System - Husqvarna K 535i Workshop Manual

6.1 To clean and examine the product parts

• Clean and examine all parts fully. You find more
instructions in the chapter for each part if special
tools or procedures are necessary.
• Replace damaged or defective parts.
• Always use original spare parts.

6.2 To repair damaged threads

1. If the plastic threads in the chassis are damaged,
make a hole with a 4.5 mm drill bit.
2. Replace the original screw with the screw 503 21
74-16 - IHSCT MT5x16.

6.3 Wet system

6.3.1 Wet system function
Each side of the blade guard has a spray nozzle. The
water hits a section of the cutting blade and the
centrifugal force moves it out to the edge.
744 - 002 -

6 Repair instructions

6.3.2 To remove the wet system
1. Remove the handle.
2. Remove the screws that hold the spray nozzles.
3. Remove the hose from the notches on the housing.
Repair instructions - 9