Ignition System - Husqvarna K770 SmartGuard Workshop Manual

6.1.13 To install the starter
Note: The starter pawls must come into the correct
position against the starter pulley sleeve.
1. Pull out the starter rope approximately 0.5 m.
2. Keep this position and put the starter against the
product.
3. Slowly release the starter rope until the starter pawls
come into the correct position.
4. Tighten the 4 screws on the starter to a torque of 7–
9 Nm.

6.2 Ignition system

6.2.1 Function
The ignition system has no moving parts and it is not
sensitive to moisture and dirt.
It is not necessary to adjust the ignition point.
The product has an overspeed protection rev limiter.
The limit is 9300 rpm.
The ignition system has a primary coil (A) and a
secondary coil (B). They are wound around an iron core
(C). An electronic digital unit (D) controls the switch
function.
The voltage sequence is in the diagram in the
illustration. The dotted line shows the voltage if the
current is not broken.
Current moves through the coil by the permanent
magnet on the flywheel. The electronic digital unit
senses the voltage in the primary coil. It breaks the
current before the piston is at the high turning point.
Until this point, the primary coil is in a closed circuit.
With an open circuit the current stops to flow and
voltage increases from 5V (Volt) to approximately 200V.
The primary and secondary coil work as a step-up
1453 - 001 - 02.04.2020
transformer. The secondary coil increases the voltage to
20 000V. This causes a spark.
C B A
B A
C
6.2.2 Ignition unit
The ignition unit is sealed and cannot be repaired. The
spark plug cable, the connection unit to the spark plug
and the seal on the ignition unit can be replaced.
1. Stop switch
2. OilGuard
6.2.3 Troubleshooting ignition system
Examine the ignition system first if the engine does not
start.
V
+
0
-
D
A
1
2
Repair and servicing - 25