NETGEAR WAC104 User Manual page 58

4. Select Advanced Setup > IP Settings.
The previous figure shows that the AP's DHCP client is enabled.
5. Configure the IP settings by taking one of the following actions:
• Disable the DHCP client and configure a static IP address by doing the following:
a. Select the Use fixed IP Address (not recommended) radio button.
b. Enter the IP address information that you collected in the IP Address, IP
Subnet Mask, Gateway IP Address, Primary DNS, and Secondary DNS
fields.
• Enable the DHCP client by selecting the Get dynamically from existing router
radio button.
6. Click the Apply button.
Your settings are saved and the AP restarts. After the AP becomes available again,
to log in to the AP local browser UI, you must use either the static IP address that
you configured or the IP address that your router or DHCP server in the network
assigned to the AP.
You can determine that IP address either by accessing the router or DHCP server or
by using an IP network scanner. (Free IP address scanner utilities are available online.)
Manage the AP and Monitor the
Traffic
802.11ac Wireless Access Point Model WAC104
58 User Manual