Change The Ip Address Settings Of The Ap - NETGEAR WAC104 User Manual

WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the AP. Wait until the AP finishes restarting and the Power LED remains solid
green.

Change the IP address settings of the AP

Under some circumstances, for example, when you move the AP from one network to
another, you might need to change the IP address settings of the AP.
For information about connecting the AP to your router or network, see Set up and
connect the AP to your router on page 17 and Connect and log in to the AP for initial
configuration on page 19.
The following procedure describes how you can either configure a static IP address or
reenable the DHCP client of the AP.
To change the IP settings of the AP:
1. Connect your computer or mobile device to the AP in one of the following ways:
• Connect directly to the AP's WiFi network or LAN.
• Connect to the same network that the AP is connected to.
2. Launch a web browser and enter http://www.aplogin.net (or aplogin.net) in the
address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use aplogin.net on page 24.
A login window displays.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The Home page displays.
Manage the AP and Monitor the
Traffic
802.11ac Wireless Access Point Model WAC104
57 User Manual