Procom BLUE FLAME MNSD100TBA Owner's Operation And Installation Manual page 13

Before installing heater to base, please make
sure you have a hardware packet that con-
tains the following items:
2 - Base Feet
4 - Sheet Metal Screws
1. Carefully lay heater on its back on a table
with the bottom of the heater extending
outside the table edge.
2. Attach base feet to heater using sheet
metal screws.
200213-01C
INSTALLATION
INSTALLATION OF BASE STAND
(If Equipped)
www.usaprocom.com
Base Feet
Sheet Metal Screws
Figure 12 - Installing Base Feet
13