Switching The Server On And Off - Fujitsu PRIMERGY TX1310 M3 Operating Manual

6.3

Switching the server on and off

V
CAUTION!
If nothing appears on the screen but flickering stripes after switching
●
on the server, switch the server off immediately (see chapter
"Flickering stripes on monitor screen" on page
The On/Off button does not disconnect the server from the mains
●
voltage. To completely disconnect it from the mains voltage, remove
the power plug(s) from the socket(s).
Do not move, strike, or shake the server when it is turned on. This can
●
damage the HDD in the server and cause data loss.
Turn the server on when the temperature is in its operating
●
environment range (10 °C - 35 °C). For details on the operating
environment, refer to "Safety Precautions".When operating the
device outside of this operating environment, the server may operate
improperly, damage data etc.Furthermore, Fujitsu cannot be held
responsible for any related damage, malfunction, or loss of data, etc.
Be sure to wait for 10 seconds or more after shutdown before turning
●
the server on.
After connecting all power cords, wait at least 10 seconds before
●
pressing the On/Off button.
TX1310 M3
Operating Manual
Starting up and operation
65).
53