Fujitsu PRIMERGY TX1310 M3 Operating Manual page 30

Important information
Do not pull on, press hard, or otherwise handle the CD/DVD/BD tray
●
roughly.
Do not disassemble the optical disk drive.
●
Before use, clean the optical disk tray using a soft, dry cloth.
●
As a precaution, remove disks from the optical disk drive when the
●
drive is not to be used for a long time. Keep the optical disk tray
closed to prevent foreign matter, such as dust, from entering the
optical disk drive.
Hold CDs/DVDs/BDs by their edges to avoid contact with the disk
●
surface.
Do not contaminate the CD/DVD/BD surface with fingerprints, oil,
●
dust, etc. If dirty, clean with a soft, dry cloth, wiping from the center to
the edge. Do not use benzene, thinners, water, record sprays,
antistatic agents, or silicone-impregnated cloth.
Be careful not to damage the CD/DVD/BD surface.
●
Keep the CDs/DVDs/BDs away from heat sources.
●
Do not bend or place heavy objects on CDs/DVDs/BDs.
●
Do not write with ballpoint pen or pencil on the label (printed) side.
●
Do not attach stickers or similar to the label side. Doing so may cause
●
rotational eccentricity and abnormal vibrations.
When a CD/DVD/BD is moved from a cold place to a warm place,
●
moisture condensation on the CD/DVD/BD surface can cause data
read errors. In this case, wipe the CD/DVD/BD with a soft, dry cloth
then let it air dry. Do not dry the CD/DVD/BD using devices such as a
hair dryer.
To avoid dust, damage, and deformation, keep the CD/DVD/BD in its
●
case whenever it is not in use.
Do not store CDs/DVDs/BDs at high temperatures. Areas exposed to
●
prolonged direct sunlight or near heating appliances are to be
avoided.
30 Operating Manual
TX1310 M3