Newtec MDM2200 User Manual page 45

Modem Web Interface
Parameter
High Band L.O.
High Band RF Start
High Band RF Stop
Current Min / Max
Transmit
MUC Multiplication
factor
MUC RF Start
MUC RF Stop
Current Min / Max
MDM2200
Description
Local oscillator frequency (in GHz) used when the LNB is operating in
high band, which can typically be found in the LNB datasheet.
Only applicable if 'Band selection' is used in 22 kHz or Voltage
settings. If 'Band selection' is not used, then only set one local oscillator
frequency (as there is no distinction between high and low band).
Minimum frequency used by the LNB when operating in high band.
Only applicable if 'Band selection' is used in 22 kHz or Voltage
settings. If 'Band selection' is not used, then only set one RF Start
frequency
(as there is no distinction between high and low band).
Maximum frequency used by the LNB when operating in high band.
Only applicable if 'Band selection' is used in 22 kHz or Voltage
settings. If 'Band selection' is not used, then only set one RF Stop
frequency
(as there is no distinction between high and low band).
Minimum/maximum allowed current on the RX interface. This input is
required for correct functioning of the current measurement test (see
section
Hardware Test on page 54
used.
Multiplication factor used by the MUC to convert from IF to RF-band
(as n*transmitted IF freq = transmitted RF freq, where n = multiplication
factor).
Minimum RF frequency the MUC can transmit.
Maximum RF frequency the MUC can transmit.
Minimum/maximum allowed current on the TX interface. This input is
required for correct functioning of the current measurement test (see
section
Hardware Test on page 54
User Manual MDM2200 R3.2 v1.1
). Not visible if single coax LNB is
).
/
42 63