Quantum LTO-3 Model B Installation Manual page 5

Figure 5 Top Access Panel
Figure 6 Removing the Drive
Blank
Installing a Second Tape Drive or Replacing a Tape Drive
LTO-3 (Model B), LTO-4 (Model B), LTO-5, LTO-6, and LTO-7
1
Adding a Second Tape Drive
Note: If you are replacing a tape drive, refer to
To add a second tape drive:
1 Remove the drive blank (see
a Pull the spring-loaded button on the right mounting rail up.
b Slide the drive blank forward and lift up out of the 1U rackmount enclosure.
Top panel
Latch screw
Replacing a Tape Drive:
Figure 6):
Spring-loaded button
Latch
2
on page 7.
2
Drive blank
5